Just received my 4500s-EE today -- awesome. Everything plugged right in, and I quickly located one wiring error (warning light on the wrong pin)...as I'm going through the setup menus, once thing I haven't yet been able to figure out...

How do I get the voltmeter and ammeter to use the values from the VP-X (Pro, if it matters)? If I go to the VP-X page, I see the values reading out there, but it appears that the voltmeter is using the internal sensor to read the primary power input, and the ammeter is looking for the shunt (which I didn't install, since it seemed redundant with the VP-X), so always reading zero. The flaps & trim, starter annunciator, etc, all display as expected.

I suppose I could disable the ammeter display and leave the internal voltmeter, then flip to the VPX page to check the amps; but it'd be nice to have the ammeter displayed along with the other gages.

Thanks!
-Joshua