AFS Quickpanel with ACM ECB.

My cabin lights are wired through ACM ECB module, with a manual switch on the panel. After the master switch is turned on, the ECB is always reset to OFF position, regardless of the physical cabin light switch position. So, to turn the cabin lights on, I have to manually reset the circuit breaker to ON, and then use the switch. The circuit will remain on until the master is switched off.

Is there any way to tell ACM ECB to follow the switch on the panel?

And another ECB question (which actually may be EFIS question - AF-5600). Since I replaced fuse based ACM with ACM ECB, when I turn on pitot heat, I get "check canopy latch" audio annunciation, and EFIS annunciation as well. Is that a misconfiguration on the ECB that I can correct?

Thanks!