Greetings,

I'm working on installing the following 'new to me' equipment:
4500sEE
ARINC
Crossbow
AFS Pilot autopilot
GNS430 (non-WAAS)
GTX327

After finishing (I thought) all the wiring, and starting system checks following the steps linked here:
http://www.advanced-flight-systems.c...ARINC-Problems
and here:
http://www.advanced-flight-systems.c...roubleshooting

I've run into some 'issues'.

1st, all references to the GNS 430 I've been able to find talk about the WAAS version; are there any wiring/configuration differences for the non-WAAS 430?

2nd, the 430 docs show tying P4001 pin 57 (GPS RS 232 in 1) to the GTX 327 P3271 pin 20 (RS232 out 1). But the AFS v7.4 install manual pg 127 shows EFIS Main pins 10/22 tied to the 430 P4001 pins 57/56. What's correct?

At this point I'm wondering what (else) I don't know. :-)

Is there anyone out there with the same set of equipment (at minimum, the 4500s, ARINC, 430, 327) that could share their wiring diagram, and if possible, 4500s configuration settings?

Thanks,

Charlie
direct email: mcsophie@gmail.com