EarthX Battery Monitor

[Shawn McGinnis]

Can you be more specific on how to utilize a "spare EFIS digital input"? (AFS 5600T with ACM)

Connect the Fault Monitoring wire (black wire out side of battery) to one of the inputs of the Aircraft Rear Connector INPUT-PFD-1 through INPUT-MFD-3.

Setup is done within the Inputs page of Instrument Configuration.

Page 186 https://www.advancedflightsystems.co...al%20V15.1.pdf

https://www.advancedflightsystems.co...%20Harness.pdf
https://earthxbatteries.com/wp-conte...l_111017_X.pdf

[cdeggz]

Shawn,
If the battery is giving a "flashing light" input to the EFIS, how is it handled? Would I see a flashing warning on the screen? Curious if a decoder was programmed in.

-Craig

Connect the Fault Monitoring wire (black wire out side of battery) to one of the inputs of the Aircraft Rear Connector INPUT-PFD-1 through INPUT-MFD-3.

Setup is done within the Inputs page of Instrument Configuration.

Page 186 https://www.advancedflightsystems.co...al%20V15.1.pdf

https://www.advancedflightsystems.co...%20Harness.pdf
https://earthxbatteries.com/wp-conte...l_111017_X.pdf