Serial Port Setup

[danbenua]

Thanks Shawn,
Are you saying there is no way to do this without upgrading the screen for the SV network and replacing
my AHRS and ADSB-in? Would my current setup work if the GPS-2020 was wired to the AF-Pilot serial
input directly?

My other alternative is to replace my Trig TT21 with a Trig TT22 and bypass the EFIS completely. The combination of
SV-2020 + TT22 is not officially supported by Trig or Dynon, but I think it should work as an ADSB out solution.

[Rob Hickman]

Do you have a touch screen?

You could use a Stratux ADS-B receiver with WiFi?

-Rob

[Shawn McGinnis]

Are you saying there is no way to do this without upgrading the screen for the SV network and replacing
my AHRS and ADSB-in?

Your desired setup only requires freeing one serial port. This would be done with the upgrade to an SV-ADAHRS-200/201. You would then have
Serial 0: AF-PILOT
Serial 1: SV-ADSB-472 (74113) or SV-ADSB-470 (74112) if you haven't done the trade in program
Serial 2: SV-XPNDR-261
Serial 3: AF-ARINC
Serial 4: GPS-2020

Would my current setup work if the GPS-2020 was wired to the AF-Pilot serial input directly?

The 2020 baud rate isn't acceptable to the AF-PILOT.

..combination of SV-2020 + TT22 is not officially supported by Trig or Dynon, but I think it should work as an ADSB out solution.

Unfortunately this won't work as the EFIS has to be involved with processing the 2020's data into transponder information.