-
GPS-250 and OAT - Advanced Deck 5600
Hi,
I have installed my GPS-250 on the PFD, using RS-232#4 on the EFIS Expansion connector, but sharing Pin 6 on the main cable for power. Additionally I have installed my OAT on the MFD also using Pin 6 for power and 7+19 for signal and ground.
When the 2 displays are connected with Crossover cable, the OAT doesn't work, but when I don't have the cross-over cable in I get OAT on the MFD - as soon as I can see the connection is established the OAT goes "---" on both the MFD and PFD.
what to do ? is this a setting or cabling issue?
rgds
Per A
Copenhagen,Denmark
RV6A - Panel upgrading.
Last edited by PAN-Denmark; 10-10-2016 at 07:43 AM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules