-
Floscan 201
Howdy,
I'm using a Floscan 201 and after 2 engine runs I see 0 fuel flow indication. I see that pin #15 is +5v. Floscan's website says that it wants 12-15v. Is there a suitable pin on the connector for that?
Thanks,
Ed Holyoke
-
you should see flow even right after startup - I see flow even when I use the fuel pump...
Are you sure the indicator in the FF needs 12v ?? Think it comes with 3 wires: +, ground, and signal, but I could be wrong...
-
Advanced Flight Systems
When we used Flowscan a long time ago they were 5v compatible. You could try feeding it with Pin 2 Trim Power at +10v to see if it works better.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules