Are you sure it is actually using more than 3 amps?
or
Switch the wire to the backup power pin and try it.
Are you sure it is actually using more than 3 amps?
or
Switch the wire to the backup power pin and try it.
Rob Hickman
Advanced Flight Systems Inc.
also.. make sure you have protection diodes on the master relay and starter relay.
Rob Hickman
Advanced Flight Systems Inc.
Because the starter relay has a power lead instead of a ground to flip it, where does the other end of the diode connect to?
err... or does it? I'm a little confused by the diagram in aeroelectric. When I installed everything I put the diode on the master solenoid, but I ended up leaving off the starter solenoid diode because I couldn't quite figure out if it was the same as the master or not.
Rob Hickman
Advanced Flight Systems Inc.