Results 1 to 4 of 4

Thread: 5600 RPM setting for 4 cyl engine, 2 blade prop, dual LSE?

  1. #1

    5600 RPM setting for 4 cyl engine, 2 blade prop, dual LSE?

    Looking for help with RPM config on the engine page set up for IO-360, 2 blade prop, dual lightspeed ignition set up. Can someone please post their working settings?

    Thanks,

    Jeff

  2. #2
    Have you tried 2 ?

    What is it doing?
    Rob Hickman
    Advanced Flight Systems Inc.

  3. #3
    no RPM indication but I think I just found the problem today. tach board output was in wrong pin location 32 instead of 33 on engine board harness. Will try running again tomorrow to check for tach indication

  4. #4
    That should fix it.
    Rob Hickman
    Advanced Flight Systems Inc.

Similar Threads

  1. Setting Flight ID
    By Pella in forum AF-5600 & AF-5500 General Discussion
    Replies: 2
    Last Post: 12-12-2014, 02:55 PM
  2. AF-5600 & ATS KRT2 Radio (lose setting)
    By Alexw in forum AF-5600 & AF-5500 General Discussion
    Replies: 10
    Last Post: 09-23-2013, 09:21 AM
  3. Setting the clock
    By wooody10 in forum AF-3400s, AF-3500s, AF-4500s ... General Discussion
    Replies: 1
    Last Post: 05-28-2013, 04:56 PM
  4. Getting all those setting correct....
    By jkgoblue in forum General Discussion
    Replies: 2
    Last Post: 04-05-2012, 06:04 PM
  5. Any way to sync Dynon D6 baro setting to AFS baro setting?
    By gribbled in forum EFIS Installation Questions
    Replies: 1
    Last Post: 04-08-2010, 04:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •