This is a continuation of a previous thread, but probably worth it's own thread.

Rather than the AFS Fuel flow sensor, I'm using the Dynon one as I did a panel upgrade and changed from Dynon to AFS.
The K-factor for the Dynon supplied fuel flow sensor should be between 290 and 320. In my case 290 was a little too low and 320 gets very close.

The problem is that the fuel readout is not stable. It changes so rapidly that it is almost unusable. Can this be changed or updated in the next software release? I used to use it for leaning purposes, but cannot do that with the current AFS setup. The Dynon provided a nice stable (and extremely accurate) readout, so it must be possible using this sensor.