Results 1 to 3 of 3

Thread: Manifold Pressure AN471-4D Assembly

  1. #1

    Manifold Pressure AN471-4D Assembly

    I acquired an AN471-4D Aeroquip fitting as recommended in the manual to connect the manifold pressure to the transducer. I need some help with how the fitting is supposed to be connected.

    A bit hard to explain in words and probably using the wrong terms, but...

    I assume that the aeroquip hose is inserted into the knurled portion, then the nipple is inserted into the AN female and connected to the flex hose from the cylinder. Then the aeroquip hose and knurled end is tightened onto the nipple/AN which should already be tight on the flex hose. I assume tightening the nipple into the knurled end will expand the aeroquip hose and make it a tight fit?

  2. #2
    Sounds correct to me.
    Rob Hickman
    Advanced Flight Systems Inc.

  3. #3
    Thanks Rob...

Similar Threads

  1. Manifold Pressure Sensor Calibration
    By Frank D in forum Engine Sensor Installation Questions
    Replies: 3
    Last Post: 07-31-2015, 01:14 PM
  2. Manifold pressure transducer
    By vickruis in forum EFIS Installation Questions
    Replies: 4
    Last Post: 10-01-2014, 09:22 PM
  3. Low manifold pressure indication
    By Dave Saylor in forum Engine Sensor Installation Questions
    Replies: 14
    Last Post: 06-10-2013, 11:06 AM
  4. Manifold Pressure Installation Questions -- RV-7A
    By BSwayze in forum Engine Sensor Installation Questions
    Replies: 4
    Last Post: 03-19-2013, 10:50 AM
  5. manifold pressure settings
    By lwfussell in forum General Discussion
    Replies: 0
    Last Post: 06-15-2010, 06:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •