Results 1 to 2 of 2

Thread: AoA Sport. Audio very faint.

  1. #1

    AoA Sport. Audio very faint.

    I have a funkwerks atr500 VHF transceiver with built in intercom. I terminated the audio lead from the supplied harness on the headphone tip. Audio is very faint and winding up the pot on the circuit board makes no difference. Is this problem because of the built in intercom and/or impedance mismatch?

    Anybody any ideas?

    thanks

    ray

  2. #2
    Pins 12 and 25 on the AOA are both audio out one is 560 ohms and one is 25 ohms. Typically, the 560 ohm output is for the audio panel with an internal amplifier and the 26ohm is for the headset jacks directly. I am not familiar with the funkwerks but you typically use an un-switched audio input on an intercom to connect the 560 ohm audio from the AOA. If your intercom doesn't have an un-switched audio input you can tie it in with the radio input.

Similar Threads

  1. rotax 912iS sport throttle position
    By neville in forum AF-5600 & AF-5500 General Discussion
    Replies: 5
    Last Post: 04-18-2015, 06:59 AM
  2. No air on 3400s EMS Sport
    By LyleM in forum AF-3400s, AF-3500s, AF-4500s ... General Discussion
    Replies: 1
    Last Post: 03-11-2014, 10:20 AM
  3. AoA Sport Wiring
    By raymac in forum Installation Questions
    Replies: 1
    Last Post: 05-08-2012, 05:06 PM
  4. no audio
    By RKURRLE in forum Installation Questions
    Replies: 6
    Last Post: 04-30-2012, 09:58 AM
  5. 4500 audio
    By amekler in forum AF-3400s, AF-3500s, AF-4500s ... General Discussion
    Replies: 8
    Last Post: 03-15-2011, 10:00 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •