Results 1 to 2 of 2

Thread: Flap Switch & Audio

  1. #1

    Flap Switch & Audio

    My AOA Pro is in a Lancair 360 installation and not yet calibrated.
    On startup I get the message "landing gear" and "AOA pass" and the AOA audio flows through a PS Engineering PMA4000.
    When depressing the flap switch, the green donut toggles on or off but there is no audio "Flaps".
    What could I have done incorrectly?


  2. #2
    If it is a ProII you should hear Flaps when the donut turns on. It does not say flaps when the donut turns off.If you have the old Pro AOA I dont think it says flaps.
    Rob Hickman
    Advanced Flight Systems Inc.

Similar Threads

  1. no audio
    By RKURRLE in forum Installation Questions
    Replies: 6
    Last Post: 04-30-2012, 09:58 AM
  2. Flap Switch Needed If Using POS-12 With AF-4500?
    By schmoboy in forum General Discussion
    Replies: 1
    Last Post: 06-14-2011, 01:08 AM
  3. flap switch location and use
    By progress in forum General Discussion
    Replies: 5
    Last Post: 03-17-2011, 01:48 PM
  4. AOA Flap Position Switch
    By NoahF in forum EFIS Installation Questions
    Replies: 1
    Last Post: 09-29-2010, 10:01 AM
  5. Flap Calibration Question
    By TrueAirSpeed in forum AF-3400s, AF-3500s, AF-4500s ... General Discussion
    Replies: 2
    Last Post: 04-11-2010, 08:42 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts