Results 1 to 2 of 2

Thread: Manifold tubin question

  1. #1

    Manifold tubin question

    The AN fitting that Van's supplies for manifold pressure is for a 1/8"tube, whereas the AFS manifold sensor uses a 1/4" tube.

    I'm interested in what other RV builders have used for this connection.

    thanks,

    bob
    Bob Leffler
    N410BL - RV10 - Flying
    http://mykitlog.com/rleffler

  2. #2

    Barbed coupler

    Hi Bob,

    I used a barbed coupler - something akin to this from McMasterCarr. You can get them in various plastics, brass, and stainless. You might also find them at your local auto parts store, too. I used a "tee" version so I could run a line up to the LSE-II ignition. For completeness, I soaked mine in avgas for a couple of days to test for fuel resistance.

    /\/elson

Similar Threads

  1. Manifold Pressure Sensor Calibration
    By Frank D in forum Engine Sensor Installation Questions
    Replies: 3
    Last Post: 07-31-2015, 01:14 PM
  2. Manifold pressure transducer
    By vickruis in forum EFIS Installation Questions
    Replies: 4
    Last Post: 10-01-2014, 09:22 PM
  3. Low manifold pressure indication
    By Dave Saylor in forum Engine Sensor Installation Questions
    Replies: 14
    Last Post: 06-10-2013, 11:06 AM
  4. Manifold Pressure Installation Questions -- RV-7A
    By BSwayze in forum Engine Sensor Installation Questions
    Replies: 4
    Last Post: 03-19-2013, 10:50 AM
  5. manifold pressure settings
    By lwfussell in forum General Discussion
    Replies: 0
    Last Post: 06-15-2010, 06:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •