Results 1 to 3 of 3

Thread: AF-Pilot standard panel mount

  1. #1

    AF-Pilot standard panel mount

    Can we get the dimensions for the area behind the panel required for the standard mount?
    Looks like a standard hole with standard screw spacing. Height and width should be standard also.

    Just need to know how far 'forward' it goes....


  2. #2
    Hi recapen,

    I used a combination of this and this to help with my layouts and hole spacing/drilling with good results.

    Dimensions for the 2-1/4" round face AF-Pilot:
    Face of the unit to the back of the aluminum enclosure: 5-3/8" (Note 1)
    Face of the unit to the back of the plastic pitot/static block: 6-1/8" (Note 2)

    1 - Allow for an additional 2-1/2" for a standard DB-25 connector w/ shell and associated wires from the rear of the aluminum enclosure. This could possibly be as tight as 2-1/4" but could pose challendges w/ wire chafing and insertion/removal/securing of the DB-25 connector itself.
    2 - Allow room for appropriate pitot/static connectors into the plastic block. Note that 1/8" NPT is used and should be hand-tightened followed by 1/2 additional turn to avoid cracking the block.

    Good luck,

  3. #3

Similar Threads

  1. AFS Autopilot Interface Panel
    By rvdave in forum General Discussion
    Replies: 3
    Last Post: 12-14-2015, 03:28 PM
  2. Mounting 5600 to Aerosport panel
    By rvdave in forum EFIS Installation Questions
    Replies: 4
    Last Post: 03-22-2015, 09:26 AM
  3. standard rate of turn
    By amekler in forum General Discussion
    Replies: 1
    Last Post: 03-10-2013, 10:36 AM
  4. 5800 Panel Cut
    By lcbowen in forum AF-5600 & AF-5500 General Discussion
    Replies: 0
    Last Post: 03-10-2013, 08:57 AM
  5. AF-4500 Tray Mount Chamfer Length
    By schmoboy in forum EFIS Installation Questions
    Replies: 1
    Last Post: 04-30-2010, 07:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts