Results 1 to 3 of 3

Thread: Rpm output on can 5600

  1. #1

    Rpm output on can 5600

    Hello, I want to know that if a Rotax 912i is connected to a can (non Skyview network model) to a 5600T it is possible to get a rpm output signal? I have a project with a propeller governor which request rpm input which I can not connect directly to the engine since it is can output.

    Thanks

  2. #2
    Possible, but as you discussed with Rob outside of the forum, it will be best to upgrade the EFIS to baseboard rev 7 and then install the SkyView EMS-221 to communicate with your iS motor.

  3. #3
    Hello Jonathon, thank you for the answer. Yes, correct, but due my present economic situation, the price of shipping the parts to USAs and the upgrade is impossible. I am still interested but not for now. My question was in terms of an already output/solution which I might be unaware and it would help a lot. Thank you
    Last edited by filiperosa; 05-05-2022 at 08:20 AM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •