Results 1 to 2 of 2

Thread: Programmed Incremental Flap positions

  1. #1

    Programmed Incremental Flap positions

    Is there a way to program incremental flap positions so the flaps move to that position with one depression of the flap switch?


    Example zero, 15 and 30.

    Thank you

    Mike
    N95VT
    Michael
    RV-10 AF-5600

  2. #2
    Hello Mike,
    Your Advanced Control Module can be reprogrammed to run in position mode, yes. The system has four programmable position stops, so you would actually want to set your RV-10 flaps up for reflex, 0, 15, and 30.

    You can engage this mode from the SET--> CAL--> Flap Position menu. Change Operation Mode from "MOMENTARY" to "POSITION", and press SAVE. From this page you will also need to program the calibration points for each of the four stops by physically moving the flaps to the reflex position for FULL UP, 0 degrees for POSITION 1, etc., and then pressing COPY for each position stop which corresponds with the physical flap position you are trying to record.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •