Results 1 to 5 of 5

Thread: Secondary ships battery monitor

  1. #1

    Secondary ships battery monitor

    Hello,
    We are upgrading to the ECB ACM this week because we want the built in backup alternator support. We are flying with an EFII electronic ignition system and its bus manager. i see the pin assignments for the two field wires, but am not finding where to input the secondary ships battery. Thanks!

  2. #2
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    861
    If you are trying to tie the second battery power input into the ACM that's setup is outside the scope what the ACM handles. You would need to combine/isolate the batteries external to the ACM.

    If you are trying to measure the second battery then it depends on which EFIS is being used AF-5000 or SkyView with EMS?
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

  3. #3
    Hi,
    This is an AF-5000 with the ECB ACM.
    Yes, all we are trying to do is measure the second battery. What pin of what connector does this tie into?
    Thanks!

  4. #4
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    861
    Pin 13 on the EFIS Expansion connector is where Volts 2 is on the AF-5000 Series displays. This pin isn't pulled through into the ACM.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

  5. #5

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •