-
Sv-arinc ifd 540
I'm installing a panel upgrade with two 5600s , IFD540, G5 and Dynon Com. I have an SV-ARINC and it does not seem to be communicating with the 540. All of my RS232 ports appear to be working:
PFD receiving AVIATION from 540 port 1.
- sending same AVIATION from 540 to ARINC on pin 3
PFD sending ARNAV to 540 on port 1 - being received as ARNAV ei-fuel
PFD receiving & sending 540 radio tuning on port 3.
MFD sending ADSB data to 540 on port 2
540 communicating with Avidyne 322 transponder (261 clone) on 540 port 2
The SV Network shows the ARINC is present. When you go to the PFD Administration Diagnostics it shows:
I was able to get the following once:
Am I missing something? Do I need to put a route in the 540 for it to communicate?
-
Rob H gave me a call. 15 minutes of config evaluation and a few changes and everything is working correctly. ARINC 429 issue was data types to/from the 540. I was guessing input as "Honeywell EFIS" from page 95 in install manual... should have been set to "EFIS/Airdata" for the 540. "GAMA 429 Graphics w/ INT" is the output setting not "GAMA 429".
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules