I am looking to install an Aithre CO monitor. Can you direct me to the correct image of the wiring diagram to refer to?
Their website is www.aithreaviation.com . Especially information to get the 5V power would be helpful.
Thanks,
Paul Collins
N8ZV
I am looking to install an Aithre CO monitor. Can you direct me to the correct image of the wiring diagram to refer to?
Their website is www.aithreaviation.com . Especially information to get the 5V power would be helpful.
Thanks,
Paul Collins
N8ZV
Interesting. The Aithre folks had me put the sensor into pin 12, the power into pin 19 and then ground to aircraft ground. It works in this set-up. Again, this is somewhat different.
Paul C
Wiring to an AF-5000 EE/EM which is with Internal Engine Monitor
Pin 12 Sensor Input (Coolant Temp reconfigured for CO)
Pin 19 Sensor 5V
Pin 37 Sensor Gnd (or any other EM ground 1,3,5,30,13,16,17,or 37)
Wiring to an AF-5000 with SV-EMS
Pin 1 Volts 1
Pin 18 Sensor 5V
Pin 17 Sensor Gnd (or any other SV-EMS ground 3, 5, 13, 16, 17, 30)
Last edited by Shawn McGinnis; 04-20-2021 at 02:41 PM. Reason: Clarity SV-EMS vs Internal Engine
Thanks for the explanation. The system works great, and so far no CO.
Paul Collins
N8ZV