Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22

Thread: 4500sEE, ARINC, GNS430 (non-waas), GTX327, AFS Pilot wiring/configuration

  1. #21
    Junior Member
    Join Date
    Jun 2015
    Location
    Slobovia Outernational (MS71), 10 N of Jackson MS
    Posts
    28
    Thanks for the input. I've got all the physical stuff, and the wiring, done successfully. I did get position lock (plane is not yet flying) by folowing Shawn's advice on Main Talker. As I mentioned earlier, I'm stuck with using the input side of the same port that feeds the transponder, so I'm limited to 9600 baud.

    Any idea which sentences are the *minimum* required for the EFIS to do it's thing? Or if a somewhat slower update rate (say, 2.5 hz) will still allow smooth synthetic vision action? I currently have only GPRMC, BPGGA & GPGSA enabled, with updates set to 5 hz. Looking at the text strings, I'm getting 5 sentences per second each for the three sentences listed, most of the time, but every few seconds it'll drop a sentence or two, as expected at 9600 baud.

  2. #22
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    861
    You might get away with dropping GSA as you are not reporting NACv to an transponder but RMC and GGA are required.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •