Results 1 to 3 of 3

Thread: Floscan 201

  1. #1

    Floscan 201

    Howdy,
    I'm using a Floscan 201 and after 2 engine runs I see 0 fuel flow indication. I see that pin #15 is +5v. Floscan's website says that it wants 12-15v. Is there a suitable pin on the connector for that?

    Thanks,

    Ed Holyoke

  2. #2
    you should see flow even right after startup - I see flow even when I use the fuel pump...
    Are you sure the indicator in the FF needs 12v ?? Think it comes with 3 wires: +, ground, and signal, but I could be wrong...

  3. #3
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    648
    When we used Flowscan a long time ago they were 5v compatible. You could try feeding it with Pin 2 Trim Power at +10v to see if it works better.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •