Hi,
sorry to bother all, but me and my aircraft electric mechanic can't work out how to connect the sensors for the Flaps and Trim to the V1 AFS 5000 (non-SV).

Out of the Elevator MAC servo/sensor there are 5 wires. 2 are white and for the motor. The rest are position sensor.
Out of the Ray Allen Flaps sensor there are 3 wires - all for position sensor.

We have a non AFS controller board for the Trim (connects to aircraft power, the trim motor and the sticks. We would not wish to use the AFS to control or supply the trim motor with power - we only want the indication on the screen - the same for the Flaps sensor.

On the Engine Sensor connect, pin 34 is flap position (IN) and pin 35 is elevator trim position (in) - but which wire of the 3 goes in here and is it enough ? Pin 2+3 are Trim power and GND (out) but since we have a control board for the trim I suppose that this is not to be used.

We are quite puzzled but the description of install manual page 157.

Can someone please help out ??

Getting to a fully ready aircraft very soon - super exited !!

cheers
Per, Copenhagen - Denmark