Results 1 to 4 of 4

Thread: IFD540 configuration details

  1. #1

    IFD540 configuration details

    For my configuration, with SV-COM, IFD-540, AFS-GPS, and the remote audio panel, the precise setup in the 5600 is not clear. I used the quick panel instructions to configure the IFD-540, but how to assign the devices in the 5600 is confusing. I currently have the SV-COM working properly through the EFIS, both for frequency selection and audio panel. The IFD-540 is available on the audio panel page, but the radio selector only shows the SV-COM.

    What is the key to getting the 5600 to control the IFD-540 COM?

  2. #2
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    674
    To tune the IFD-540 you will need the serial port setup for GTR/GNC-2xx and the COM setup page set for GNC-255. At this time only one radio is tuned from a display.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

  3. #3
    Perhaps that would be a function in the future, to tune two radios from the 5600?
    Dave Ford
    RV10

  4. #4
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    674
    Perhaps. You can currently tune two radios with two EFIS.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •