-
Thanks Shawn,
There were actually only a couple differences and I was able to remap them in the calibration function as suggested. I have canopy closed switches (Normally closed and connected to ground with doors closed) wired to a couple general purpose inputs on the EMS module. I can't find anywhere in the installation manual where i can activate a pin. Will I have to change the wiring to connect to the EFIS Main Harness pin 8, 17 or 20?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules