Results 1 to 4 of 4

Thread: Modify EMS sensor pin assignment

  1. #1

    Modify EMS sensor pin assignment

    I installed the EMS-220 according to Dynon's instructions for the skyview then decided to change to AF-5600 panels instead. Many of the sensors use different pins in the AFS instructions. Can I change the sensor pin assignments in the software or do I need to rewire?

  2. #2
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    861
    The majority of sensors can be remapped using the Pin Select function within calibration.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

  3. #3
    Thanks Shawn,

    There were actually only a couple differences and I was able to remap them in the calibration function as suggested. I have canopy closed switches (Normally closed and connected to ground with doors closed) wired to a couple general purpose inputs on the EMS module. I can't find anywhere in the installation manual where i can activate a pin. Will I have to change the wiring to connect to the EFIS Main Harness pin 8, 17 or 20?

  4. #4
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    861
    Yes, you will need to move the pins, current software doesn't support the GPI from the SV-EMS.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •