Modify EMS sensor pin assignment

[Colin]

I installed the EMS-220 according to Dynon's instructions for the skyview then decided to change to AF-5600 panels instead. Many of the sensors use different pins in the AFS instructions. Can I change the sensor pin assignments in the software or do I need to rewire?

[Shawn McGinnis]

The majority of sensors can be remapped using the Pin Select function within calibration.

[Colin]

Thanks Shawn,

There were actually only a couple differences and I was able to remap them in the calibration function as suggested. I have canopy closed switches (Normally closed and connected to ground with doors closed) wired to a couple general purpose inputs on the EMS module. I can't find anywhere in the installation manual where i can activate a pin. Will I have to change the wiring to connect to the EFIS Main Harness pin 8, 17 or 20?

[Shawn McGinnis]

Yes, you will need to move the pins, current software doesn't support the GPI from the SV-EMS.