Results 1 to 4 of 4

Thread: Manifold Pressure Sensor Calibration

  1. #1
    Junior Member
    Join Date
    Apr 2010
    Location
    Ponte Vedra Beach FL, Point Pleasant Beach NJ
    Posts
    22

    Manifold Pressure Sensor Calibration

    I can not find the MAP calibration process in the 5000 series manual, nor on a search of the forum.

    In the set up menu I think there are 2 value points?

    What is the process for the calibration?

    Thanks
    Frank

  2. #2
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    861
    Press SET -> Hold CAL
    Use the joystick to navigate to Manifold and SELect

    From here the parameters can be set. Allow the screen 15 minutes to reach a steady state before adjusting values.
    First ensure the part number matches the device installed.
    Next perform a shift adjust to the current airfield baro reading. The upper right hand corner reflects the adjusted value.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

  3. #3
    Junior Member
    Join Date
    Apr 2010
    Location
    Ponte Vedra Beach FL, Point Pleasant Beach NJ
    Posts
    22
    Are there 2 Cal Points? Can I reset them to factory prior to the shift adjustment?
    Thanks,
    Frank

  4. #4
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    861
    Changing the part number will reset the table back to factory standard.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

Similar Threads

  1. Manifold pressure transducer
    By vickruis in forum EFIS Installation Questions
    Replies: 4
    Last Post: 10-01-2014, 09:22 PM
  2. Low manifold pressure indication
    By Dave Saylor in forum Engine Sensor Installation Questions
    Replies: 14
    Last Post: 06-10-2013, 11:06 AM
  3. Manifold Pressure AN471-4D Assembly
    By schmoboy in forum EFIS Installation Questions
    Replies: 2
    Last Post: 04-04-2013, 08:37 AM
  4. Manifold Pressure Installation Questions -- RV-7A
    By BSwayze in forum Engine Sensor Installation Questions
    Replies: 4
    Last Post: 03-19-2013, 10:50 AM
  5. manifold pressure settings
    By lwfussell in forum General Discussion
    Replies: 0
    Last Post: 06-15-2010, 06:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •