Results 1 to 2 of 2

Thread: Afs comm no squelch control

  1. #1

    Afs comm no squelch control

    I've got the AFS comm installed, configured to network, but cannot control squelch thru inst calibration. It shows up as SV-Com-Panel, enabled. I have open squelch on headphones, can hear transmitted audio, but cannot close squelch thru control on efis. Do have the network cable attached and can swap from efis. Goes to normal if I turn comm off. Not sure where to go from here.
    Last edited by rvdave; 07-16-2015 at 07:48 AM.
    Dave Ford
    RV10

  2. #2
    Operator error I found out accidentally, the squelch doesn't actually change until setting is saved, problem solved, or rather resolution discovered.
    Dave Ford
    RV10

Similar Threads

  1. AFS Comm Wire Schematic
    By BSteeves in forum Technical Support Documents
    Replies: 1
    Last Post: 06-23-2016, 02:16 PM
  2. Remote comm installation
    By sahrens in forum AF-5600 & AF-5500 General Discussion
    Replies: 8
    Last Post: 10-27-2015, 10:43 AM
  3. Autopilot control
    By rvdave in forum AF-5600 & AF-5500 General Discussion
    Replies: 3
    Last Post: 05-26-2015, 12:13 PM
  4. GPS COMM won't comunicate with 3500s or 3400s
    By LyleM in forum AF-3400s, AF-3500s, AF-4500s ... General Discussion
    Replies: 4
    Last Post: 05-18-2014, 08:16 AM
  5. AFS Comm & VAL Comm 2KR
    By rv8iator in forum Announcements & Info
    Replies: 1
    Last Post: 11-01-2012, 04:12 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •