Results 1 to 2 of 2

Thread: Kavlico sensors on 3400 EM

  1. #1

    Kavlico sensors on 3400 EM

    I removed my VDO oil and fuel sensors and installed the new Kavlico 3 wire sensors per the electrical print for my 3400 EM. I turned my boost pump on for a couple seconds and it went over 1200 psi on the indecator. I went into the fuel and oil pressure settings to change to the new Kavlico senders but they were not on the list to select from. I am running version SW:S8.8.29-MV16 on my AF-3000s engine monitor. How should I address this???

    Don

  2. #2
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    861
    Change the Num Cal Points first then the table to reflect the values below.

    Fuel Pressure Sensor:





    Name:  image.jpg
Views: 308
Size:  18.1 KB



    Oil Pressure Sensor:




    Name:  image (1).jpg
Views: 327
Size:  18.9 KB


    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

Similar Threads

  1. Kavlico Oil Pressure Sensor and Hobbs Meter
    By George Costigan in forum Engine Sensor Installation Questions
    Replies: 1
    Last Post: 05-16-2016, 12:32 PM
  2. What's needed to convert to using Kavlico sensors for a 4500?
    By dnelson in forum Engine Sensor Installation Questions
    Replies: 4
    Last Post: 04-19-2015, 10:46 AM
  3. Oil Pressure Sensor: Kavlico P4055-150
    By billrv7 in forum General Discussion
    Replies: 3
    Last Post: 07-16-2013, 07:04 PM
  4. Dual OAT Sensors
    By Paul Winkels in forum AF-3400s, AF-3500s, AF-4500s ... General Discussion
    Replies: 1
    Last Post: 09-09-2010, 09:35 AM
  5. Sensors for AF2500 vs 3500EE
    By terrydilley in forum Engine Sensor Installation Questions
    Replies: 5
    Last Post: 05-14-2010, 08:10 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •