Results 1 to 3 of 3

Thread: Expansion cable connection

  1. #1

    Expansion cable connection

    Im hooking up the afs gps to the expansion connector. One diagram shows drawing power from pin 1 of expansion receptacle, another shows drawing power from main cable pin 6, the old oat terminal. Is either/both correct?
    Last edited by rvdave; 01-22-2015 at 01:26 PM.
    Dave Ford
    RV10

  2. #2
    Ok I see p 237 shows 8v out @ 350 ma for pin 1. This should be ok for afs gps?
    Dave Ford
    RV10

  3. #3
    If you purchased your EFIS in the last 15 months you have REV 7 hardware.

    http://www.advanced-flight-systems.c...al%20V3.00.pdf

    Page 152
    Rob Hickman
    Advanced Flight Systems Inc.

Similar Threads

  1. Expansion cable connection
    By rvdave in forum EFIS Installation Questions
    Replies: 2
    Last Post: 01-22-2015, 06:45 PM
  2. Audio Warnings - expansion ?
    By Mastro in forum General Discussion
    Replies: 5
    Last Post: 10-13-2013, 05:35 PM
  3. EFIS Expansion connector
    By rv8iator in forum EFIS Installation Questions
    Replies: 1
    Last Post: 09-20-2012, 09:23 AM
  4. Cable Harness Question
    By rleffler in forum EFIS Installation Questions
    Replies: 5
    Last Post: 11-29-2011, 11:31 AM
  5. EFIS Expansion Connector
    By MarkM in forum AF-3400s, AF-3500s, AF-4500s ... General Discussion
    Replies: 1
    Last Post: 10-21-2011, 04:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •