Results 1 to 2 of 2

Thread: Baro Pressure setting problem

  1. #1

    Baro Pressure setting problem

    The other day as I changed ATC units the baro pressure changed from 1010mb to 1008mb. However my AF4500 would not let me set 1008, it kept jumping between 1009 and 1007. In the end I gave up and accepted the altitude reading was 30ft out.

    Has anyone else seen this kind of problem? This is the first time it has happened to me in 2 years and >100 hours.

    On a completely different subject, I have to change out my GPS feeding into the 4500 and am considering using a AFS 73101 remote GPS. Is this 'plug & play'? How is power provided to the GPS?

    Peter

  2. #2
    I have seen this, except I thought I was unable to select 1009, maybe it was 1008. I've had it where I could select it 5 minutes later and then other times not. Like you I haven't been too bothered.

Similar Threads

  1. fuel pressure, oil pressure warnings
    By RKURRLE in forum AF-3400s, AF-3500s, AF-4500s ... General Discussion
    Replies: 3
    Last Post: 06-19-2016, 04:14 AM
  2. Setting Flight ID
    By Pella in forum AF-5600 & AF-5500 General Discussion
    Replies: 2
    Last Post: 12-12-2014, 02:55 PM
  3. Fuel Pressure and Oil Pressure pegged high
    By gribbled in forum Engine Sensor Installation Questions
    Replies: 2
    Last Post: 03-28-2013, 06:37 AM
  4. Getting all those setting correct....
    By jkgoblue in forum General Discussion
    Replies: 2
    Last Post: 04-05-2012, 06:04 PM
  5. Any way to sync Dynon D6 baro setting to AFS baro setting?
    By gribbled in forum EFIS Installation Questions
    Replies: 1
    Last Post: 04-08-2010, 04:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •