Great!
On a related question, my Stein built harness from the GTN650 sends rs232 to pin 19, with icarus altitude from 5600 sent to pin 2.
Your diagrams have the icarus from the 5600 to pin 19 - will there be problems with this setup?
Phil
Great!
On a related question, my Stein built harness from the GTN650 sends rs232 to pin 19, with icarus altitude from 5600 sent to pin 2.
Your diagrams have the icarus from the 5600 to pin 19 - will there be problems with this setup?
Phil
Pin 19 on the EFIS is a ground pin?
Rob Hickman
Advanced Flight Systems Inc.
Sorry - Pin 2 and Pin 19 on the GTX327.
Your recommended drawing has icarus output from the 5600 going to pin 19 on the transponder. Stein has wired the GTN650 output to pin 19 on the transponder, and his wiring schematic puts the AFS 5600 icarus output to Pin 2 on the transponder. I wanted to make sure these two inputs didn't conflict with each other
You will have to ensure the configuration on your GTX-327 matches the wiring on the harness. If the AFS-5600 is wired into pin #2, confirm the configuration for that serial port is ICARUS ALT. You don't have to swap serial ports on the GTX-327.
Isaac Becktold