Search:

Thanks for the explanation. The system works great, and so far no CO.
Paul Collins
N8ZV

Interesting. The Aithre folks had me put the sensor into pin 12, the power into pin 19 and then ground to aircraft ground. It works in this set-up. Again, this is somewhat different.
Paul C

I am looking to install an Aithre CO monitor. Can you direct me to the correct image of the wiring diagram to refer to?
Their website is www.aithreaviation.com . Especially information to get the...

Interested as well.

I tap on the right side of the screen to pull up various options (I have a 5400). Then I tap on approach option, tap the lower right knob and get to the correct approach plate and select that. When...

Yes, the software has been updated.
Paul Collins
N8ZV

When I set an approach plate up on my 5400, I only have about 30 seconds to move the approach plate around on the screen before it "locks up". To move/adjust it again I need to effectively re-load...

Ok, I tried it and it worked! Here is what I did to change to approach airport for the plates;
Push D (direct)
dial in the proper airport
push the right knob (On the 5400)
select APPRCH
Make...

I will try as well. It might be some quirk (?correct word?) on my system. We shall see.
Thanks, and on we go,
Paul Collins
N8ZV

So, you start with a direct-to entry? Does that change the APPLATE display reference airport?
Paul Collins
N8ZV

No, I have not been doing a direct flight with the AFS 5400 - I do that on the IFD440. Maybe I need to set the direct course with the AFS and see if the 440 then works with the new approach.
Paul...

Well, what happens is when I load an approach on the IFD440, with the Advanced Flight Systems 5400 set on CDI/GNAV1 in both sites, the first approach loaded shows up on the APPLATE view (You get...

I have a 5400 that is linked to an IFD 440. When I load an approach on the IFD 440, the approach plates are called up on the 5400. The problem is, when I load a new airport on the IFD 440 and load...

Thanks! I very much appreciate the help.
Paul Collins
N337DP

Don't know if this go lost in the shuffle. Again, with a synthetic self-made approach, how does one delete this and start over? Thanks, PCC

So, how does one delete synthetic approaches on a 5400?
Thanks,
Paul Collins
N8ZV

Thanks, this will help.
Paul Collins

I have a similar question. I installed the 6ah TCW backup battery for my 5400, and it seems now to be charging and staying fully charged - but - my question is if I start the 5400 to be running on...