Search:

Type: Posts; User: Lagonia

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    152

    Manifold pressure indication gone

    I have an AFS 4500 with an O-360 engine on my RV9.
    Went flying yesterday and all was good.
    Today on start up I first had an intermittent manifold pressure indication on my EFIS, indication then...
  2. Replies
    3
    Views
    298

    That’s a little confusing. Are you saying that...

    That’s a little confusing. Are you saying that when I have my EFIS in Lat Nav, Vertical will automatically switch to Arm? I understand having Lat in Nav to follow the course, not in HDG. But please...
  3. Replies
    3
    Views
    298

    Flying an LPV approach

    When flying an LPV approach do I need to manually switch from Vertical Alt to Vertical Arm or will my 4500 switch automatically?
  4. Replies
    2
    Views
    1,710

    Thank you Shawn. Will check that out tomorrow.

    Thank you Shawn. Will check that out tomorrow.
  5. Replies
    2
    Views
    1,710

    How to check oil temp sensor

    On my last flight the oil temp registered between 117-134F. It was during a three hour cross country flight. Previous flight was 2.5 hours and oil temp was right below 180F. Before I install an oil...
  6. Replies
    4
    Views
    1,864

    I do,have two questions. I have SV on my PFD...

    I do,have two questions.
    I have SV on my PFD but not on the MFD so I do not get terrain alerts, red, on my MFD which is used for my navigation map. What do I need to install to get terrain info on...
  7. Replies
    4
    Views
    1,864

    Don’t have any bugs that I know of. Just asking...

    Don’t have any bugs that I know of. Just asking if AFS will be adding any features for legacy units, I have dual 4500’s, like you folks do for the latest 5000 series units.
  8. Replies
    4
    Views
    1,864

    Software updates for legacy units?

    I understand your focus on the AF-5600 units but is there any chance you will offer software updates for the AF-4500 series? I
  9. Thread: ADS-B for 4500

    by Lagonia
    Replies
    17
    Views
    15,600

    Would the GDL-52 R work for ADS-B in with the...

    Would the GDL-52 R work for ADS-B in with the AF-4500? Right now I
  10. Replies
    9
    Views
    4,952

    Shawn, are you saying that on the MFD I now need...

    Shawn, are you saying that on the MFD I now need to change the GPS/NAV Data Source 2 (on the MFD) to Remote Nav?
  11. Replies
    9
    Views
    4,952

    I made the changes to my configuration as you...

    I made the changes to my configuration as you folks suggested to me on a Facebook post. I still have one question. AFS comment said for me to decide how my SL-30 was wired and it should only be...
  12. Replies
    9
    Views
    4,952

    I should add that the SL-30 is wired to the PFD.

    I should add that the SL-30 is wired to the PFD.
  13. Replies
    9
    Views
    4,952

    Thank you Shawn. I do have an AF-ARINC module. ...

    Thank you Shawn. I do have an AF-ARINC module. I think the issue may be the configuration of the Serial Ports. PFD is configured as follows: Port 1 AVTN/AVTN, Port 2 TRFC/ICARUS, Port 3 SL-30, and...
  14. Replies
    9
    Views
    4,952

    I also have the select switch to control the...

    I also have the select switch to control the vizion through the EFIS or the GPS.
  15. Replies
    9
    Views
    4,952

    Configuring the AFS 4500 dual screens

    I have dual AFS 4500 screens.
    I recently installed an ARINC 429, the TruTrak Vizion 385 and a Garmin 175. I am trying to control my autopilot from my EFIS. How should my screens be configured? ...
  16. Replies
    4
    Views
    3,485

    That is great to learn. I would much prefer to...

    That is great to learn. I would much prefer to see my geo referenced plates on my EFIS rather than my iPad.
  17. Replies
    4
    Views
    3,485

    How do you get the geo referenced approach plates...

    How do you get the geo referenced approach plates to show on my 4500? I have been using my iPad with Foreflight but would prefer to see them on my AFS 4500 moving map. I have a Jeppesen...
  18. Replies
    1
    Views
    2,285

    Sky pointer or ground pointer indication

    Is there a way to choose between a ground pointer or sky pointer indication for the attitude indicator? Cannot find anything in the manual.
  19. Replies
    5
    Views
    3,471

    Thank you sir. I did see your more detailed...

    Thank you sir. I did see your more detailed answer.
  20. Replies
    5
    Views
    3,471

    With the ARINC module if I upgrade to the TruTrak...

    With the ARINC module if I upgrade to the TruTrak Vizion 385 autopilot will I be able to fully command all altitudes, preselect, select, step down, LPV approach m
  21. Replies
    1
    Views
    2,147

    ADS-B In for the 4500

    Has anyone used the Echo UAT ADS-B with their AFS 4500 system? If so, how well does the ADS-B In function? Does it do a good job of showing traffic on your EFIS screen? For those that have used...
  22. Replies
    3
    Views
    2,644

    Then to,confirm my understanding, if my EFIS said...

    Then to,confirm my understanding, if my EFIS said I burned 13.1 gallons but when fueling I could only put in 9.38 gallons then 13.1/9.38=1.396 or 1.4. I now take the K Factor that is in my EFIS, 680,...
  23. Replies
    3
    Views
    2,644

    Gallons used incorrect

    Still learning about my 4500 system. Tracked my gallons used from each tank this week on a few flights to see how accurate my indication was. EFIS said I used 4.3 gallons from left tank but when...
  24. Replies
    5
    Views
    3,471

    Thank you Shawn. Much appreciated

    Thank you Shawn. Much appreciated
  25. Replies
    5
    Views
    3,471

    Questions for Shawn McGinnis

    I have dual 4500 screens in my RV 9. Just sent Rob an email with these questions but thought he may be busy getting ready for Sun n Fun and maybe my questions can be answered here.
    I am finally...
Results 1 to 25 of 35
Page 1 of 2 1 2