Search:

Type: Posts; User: recapen

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    4,248

    Thanks Shawn!

    Thanks Shawn!
  2. Replies
    2
    Views
    4,248

    Fixed gear calibration

    With my older separate box unit - I did the calibration procedure this weekend. After the procedure was finished for flaps up and down, I got the landing gear warning continuously until I powered...
  3. Replies
    1
    Views
    2,324

    3400s screen issues

    Flew two weekends ago and the screen took some time to stabilize, it was splashing colors, pixels, and lines all over the place before it stabilized.
    Today after updating the map data, the screen...
  4. Shawn makes a great point here - I had taken mine...

    Shawn makes a great point here - I had taken mine apart and bench checked it before I even asked.....
  5. Marcus - your email just bounced - says it is...

    Marcus - your email just bounced - says it is full......
    Ralph
  6. Replies
    13
    Views
    9,139

    Test re-ran and completed. This time, the test...

    Test re-ran and completed. This time, the test ran for 1:17 - significantly batter than the 31 minutes last time.
    Sounds like that battery gets to hang around for a little while longer.
  7. Replies
    13
    Views
    9,139

    I'm re-running my battery test after a 1.6 hour...

    I'm re-running my battery test after a 1.6 hour flight - that should have fully charged it.
    I know there were issues preventing it from shutting down properly before - hopefully they have now been...
  8. I just did the backup / upgrade to 8.8.35 /...

    I just did the backup / upgrade to 8.8.35 / restore sequence today. Don't know if that might have fixed my earlier problems.
    Either way, I have the latest software available and a configuration...
  9. Replies
    13
    Views
    9,139

    Mine's definitely NOT fresh - 31:36 was the...

    Mine's definitely NOT fresh - 31:36 was the duration.
    Been in service for 7+ years and about 350 startup cycles. I start my unit prior to engine start and run it on the battery until I get the...
  10. Set it to 869 since the next setpoint was 929 and...

    Set it to 869 since the next setpoint was 929 and the instructions indicated a 50 point minimum difference - works fine.
    Thanks for everyone's help on this one!
  11. Excellent - thanks - another thing to do this...

    Excellent - thanks - another thing to do this weekend......
  12. Replies
    13
    Views
    9,139

    Thanks - I'll check that one out this weekend!

    Thanks - I'll check that one out this weekend!
  13. In this case, the airspeed went to zero WITH the...

    In this case, the airspeed went to zero WITH the cover on. I'm trying to get the machine to ignore ground wind.
    Would increasing the "AIRSPEED.AD_VALUE_1" setting to a higher number like 860 help...
  14. Replies
    13
    Views
    9,139

    What is the normal lifespan of the backup...

    What is the normal lifespan of the backup battery?
    How can I tell if it needs to be replaced?
    Thanks!
  15. After the flight, it still showed 28 KIAS of...

    After the flight, it still showed 28 KIAS of airspeed - I manually shut it down.
    After getting it in the hangar and putting the pitot tube cover on, I restarted it to get my data - airspeed shows...
  16. Using the instructions provided, it appears to...

    Using the instructions provided, it appears to have set things to working correctly again!

    Here's what the AIRDATA.AFC file looks like now:

    AIRSPEED.NUM_CAL_PTS, 16
    AIRSPEED.TEMP_CAL_AD_VALUE,...
  17. I called in and the gent I talked to indicated...

    I called in and the gent I talked to indicated you would send an instruction set as I am not local to the plane during the week.

    Thinking the instruction set is for the screen interface.

    I'm...
  18. On the ground - in the hanger - EFIS says we're doing 29-31 KIAS!

    I have checked my entire pitot and static systems for a blockage.
    Went so far as disconnecting the pitot and static sources at the back of the display - still shows airspeed.

    Is there a way to...
  19. Replies
    3
    Views
    3,145

    Feature Request

    Would you consider a software change to tie the fuel pressure and oil pressure calibration to the ambient pressure? Even if it was only on startup....

    As the pressure changes due to different...
  20. Replies
    1
    Views
    2,594

    Backup power for ARINC converter

    Is there an option to provide backup power to the ARINC converter?
    Since I have a battery backup for my AFS3400EE and it is not on the essential bus, I was thinking about the ARINC converter...
  21. Replies
    76
    Views
    38,840

    When does it go "Live"? What's the version...

    When does it go "Live"?
    What's the version Number?
    Always interested in the latest and greatest from you guys!
  22. Replies
    9
    Views
    5,451

    Flight results were good - sender acted like it...

    Flight results were good - sender acted like it was a brand new one.
    Don't know whether I was able to actually clean it or simply shaking the old fuel out was sufficient.

    New sender to be ordered...
  23. Replies
    9
    Views
    5,451

    I was able to get mine removed this weekend as...

    I was able to get mine removed this weekend as part of a scheduled oil change.
    I shook out the original fuel that was in it - the hole was small so I am not sure how much I was able to get back in...
  24. Replies
    9
    Views
    5,451

    In my case, the sensor failed internally -...

    In my case, the sensor failed internally - vibration took out the internal ground - right after take-off. Other indications were normal but I circled back around to an uneventful landing.
    If I...
  25. Replies
    9
    Views
    5,451

    Similar issue with mine recently - had the cowl...

    Similar issue with mine recently - had the cowl open so I released the pressure (if any) by disconnecting the sense fuel line from the mechanical pump to the sensor...then I gently tapped on the...
Results 1 to 25 of 81
Page 1 of 4 1 2 3 4