My AOA system uses the flap position sensor to change presets. Would there be much to adding a flap alarm based on airspeed and flap position instead of the older AOA closure from the manual? Does...
Type: Posts; User: jdeas
My AOA system uses the flap position sensor to change presets. Would there be much to adding a flap alarm based on airspeed and flap position instead of the older AOA closure from the manual? Does...
The temp fix for the 300XL was to use com2 configured NMEA 0183 (listed as mapping output in the 300XL) sent to com0 in the AFS then used it as the third nav source. This will do until the new puck...
Finished wiring my serial communications as follows
Com1 - AFS Pilot
Com2 - Aviation/Icarus (300XL source, GMA327 destination)
Com3 - SL-30
Com4 - Airinc
Two items not understood.
1) The...
Pulled out and connected only the bu batt. LEDs, one solid one blinking while holding btn 1 down. Still a black screen.. also tried a second battery
Just replaced my 4500 with the 5600.
Power was expanded to the two main power and two master gnd connections. I backup battery was also installed.
When applying power the Ethernet jack led's blink...
I'll check that this weekend. If the 4500 only sets parameters in the GPS unit then that may be my problem. The 300XL is an old unit and not listed on any examples. I have my doubts that it can...
AF-4500 , 300XL, AP
Course interception using the 300XL directly works very well with the AP however using the FD I have wild overshoots coming onto a heading. Because the 300XL is intercepting so...
I didn't see a way on the 4500 to display the Arinc labels but changing the King EFS did change the way to EFIS reacted on powerup. What is the input impedance of Arinc inputs? I'd like to make sure...
Making sure I have this right. 300XL GPS1 is set to aviation and is being understood by the AP(9600) and EFIS(AVTN/ARNAV) . However what settings should be used for the 300XL's AIRINC?
Inputs...
The manual only shows hooking up the AFpilot to the 430/530 devices. There is no direct correlation to 300XL port settings.
After working through the EFIS troubleshooting guide, and updating the...