Search:

Type: Posts; User: Rob Hickman

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    5
    Views
    633

    Byron, We show you filled out the form on May...

    Byron,

    We show you filled out the form on May 9th at 11:28AM and Don responded on May 10th at 3:38pm

    Have you checked your SPAM folder?
  2. You can't change it.

    You can't change it.
  3. Replies
    1
    Views
    406

    It is either the wiring or a bad sensor. Check...

    It is either the wiring or a bad sensor. Check the voltage on the signal wire, should be around 4+ volts
  4. Replies
    2
    Views
    361

    We have a number of people with it connected to...

    We have a number of people with it connected to an EFIS digital input, I have it in both of my planes.
  5. Replies
    5
    Views
    633

    The best way to contact us is to email...

    The best way to contact us is to email support@Advanced-Flight-Systems.com
  6. Replies
    5
    Views
    633

    When did you post on the contact form and under...

    When did you post on the contact form and under what name?
    I will see if our IT People can figure it out
  7. Replies
    2
    Views
    1,465

    Are you running the latest software? What NAV...

    Are you running the latest software?

    What NAV Radio are you using?

    What are you using for a NAV Antenna?

    Have you tried it with the lights and strobes turned off?
  8. Replies
    22
    Views
    29,709

    The new AF-5000 Videos are: ...

    The new AF-5000 Videos are:

    https://www.youtube.com/channel/UC4uxyWWIBLW5dXqRmzOWKug?view_as=subscriber
  9. Only the AF-5000 has the ability to use the Dynon...

    Only the AF-5000 has the ability to use the Dynon GPS-250 to drive the synthetic vision while following a GPS Navigator. The Pitch, Roll and Heading comes from the AHRS and has nothing to do with...
  10. Replies
    2
    Views
    1,485

    This is a page from the new manual we are working...

    This is a page from the new manual we are working on:

    454

    Rob Hickman
  11. The SV-ARINC module does not use any of the EFIS...

    The SV-ARINC module does not use any of the EFIS serial ports. If you want fuel flow to the navigator you will need to use one of the EFIS serial ports configured as EI FUEL to send the data to the...
  12. Replies
    7
    Views
    2,869

    Notes on connecting ADS-B - Always use ADS-B...

    Notes on connecting ADS-B

    - Always use ADS-B 115K , 57K is not fast enough to get all the data
    - Only configure 1 EFIS screen to ADS-B 115K , make sure you don't have any other serial ports...
  13. Replies
    7
    Views
    2,869

    ADS-B Data

    What did the Nexrad age show on the AF-5600 EFIS?
    What did the iFly show for the Nexrad age?
    What serial port ADS-B data speed do you have selected on the AF-5600?

    What version of software are...
  14. Replies
    12
    Views
    6,498

    Page 135 of the install manual shows the correct...

    Page 135 of the install manual shows the correct pins for the capacitance tanks.
  15. Replies
    2
    Views
    2,992

    Change the pulses per rev setting in calibration

    Change the pulses per rev setting in calibration
  16. Replies
    2
    Views
    2,494

    Email the system and serial port data log to...

    Email the system and serial port data log to ken@advanced-flight-systems.com

    When you press the system log button on the EFIS that is wired to the ADS-B it should save the adsb serial port logs on...
  17. Replies
    2
    Views
    2,656

    You are in vertical flight plan mode and have...

    You are in vertical flight plan mode and have altitudes set for each way point.
  18. Replies
    6
    Views
    4,638

    Do you have a touch screen? You could use a...

    Do you have a touch screen?

    You could use a Stratux ADS-B receiver with WiFi?

    -Rob
  19. Replies
    2
    Views
    2,685

    New AF-5000 Pilots Guide Manual

    The updated manual is available:
    http://www.advanced-flight-systems.com/docs/AF-5000%20Pilot%20Guide%20Manual%20V15.0.pdf
  20. Replies
    5
    Views
    2,577

    When you select NAV mode the autopilot will be in...

    When you select NAV mode the autopilot will be in ARM mode and the NAV touch button will be dark yellow. The autopilot will continue to use HDG mode or TRK mode until the GPS ground track is within...
  21. The CRS knob should change it. The Indicator...

    The CRS knob should change it.

    The Indicator Head Type setting should be set to SERIAL in the SL30. This will enable the OBS to be set from the SL30 buttons and from the EFIS.
  22. Replies
    1
    Views
    1,717

    The IFD-540 wires just like the 430W/530W and...

    The IFD-540 wires just like the 430W/530W and does not require 6 ARINC inputs. Send me an email and I can send you a drawing.

    Rob@Advanced-Flight-Systems.com
  23. Replies
    10
    Views
    5,712

    In this picture the EFIS is in OBS mode from the...

    In this picture the EFIS is in OBS mode from the Garmin Navigator, or the EFIS thinks the 430W it is in OBS mode.

    Can you double check if the OBS button on your 430W is controlling the EFIS map...
  24. Try doing a SET NVRAM DEFAULTS in the calibration...

    Try doing a SET NVRAM DEFAULTS in the calibration menu, you will need to set the Page List, Knob List, Pitch and Autopilot EFIS settings.
  25. Replies
    3
    Views
    2,960

    Yes, it will also give you IAS climb mode

    Yes, it will also give you IAS climb mode
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4