The slip/skid ball seems to be skewed to the right, even when the plane is sitting on the ground and perfectly level (measured with a digital level). Is there any way to adjust this?
Also, does...
Type: Posts; User: chuckwn2
The slip/skid ball seems to be skewed to the right, even when the plane is sitting on the ground and perfectly level (measured with a digital level). Is there any way to adjust this?
Also, does...
Thanks Rob. What about the gain when in NAV mode?
I have an AFS pilot connected to an AF 5500.
Works GREAT in cruise and for climb and descent.
The issue is this:
When the AFS is in "heading" mode, it does not turn aggressively enough when...
Is it possible to adjust the GAL REM value without changing the GAL USED value or do they always add together to equal the total fuel tank size?
I would like the GAL USED to be 0.0 at the...
If a backup battery is connected to the backup power pin on the DB-15 expansion connector, and power is lost on the primary power pins on the main connector, does the EFIS behave like the previous...
Thanks Rob. For the other settings that can be moved, is this the procedure?
1) Transfer settings files from the 3400S to SD card
2) Put SD card with settings into the 5500
3) load settings...
Is there a way to transfer all the settings, particularly the magnetometer calibration data when upgrading from a 3400S to a 5500? I am using the original magnetometer in its original location.
...
Will be installing a 5500 with engine board soon and am upgrading from the "Van's" engine instruments.
Are the Van's Stewart Warner transducers compatible with the 5500 engine monitor,...
Trevor,
Is an RS-232 connection between the GPS and EFIS not required because the navigation information is being passed to the EFIS through the ARINC module?
Thanks,
Chuck
Trevor,
I am planning installation of a second screen. Both screens will have air data input. I would like to share the output of one OAT probe with both screens.
It is my understanding that...
Is it possible to share the output of one AFS OAT probe with two AFS EFIS's? My apologies if this question has been answered here before.
I realize that the probe will be powered by only one...
How is the pitch trim position display enabled/disabled?
Thanks,
Chuck
RV-8
AFS-3400s
Hi Dave,
Perhaps it is not seeing a steady ARINC data stream?
Cheers,
Chuck
Will the AFS pilot work with a GX60 and an SL30? Specifically turn anticipation and ILS capture?
Thanks,
Chuck Newman
RV-8
AFS-3400S
I am using a GX60 with a 3400S. It is compatible and is a fine radio too.
Bump to top. Anyone know?
Is there any way to turn off the "Standard Rate Turn" triangle indicators that are on the bank angle scale?
Thanks,
Chuck