Search:

Type: Posts; User: Bill Rogers

Search: Search took 0.02 seconds.

  1. Replies
    3
    Views
    6,641

    I have had it set there before, but I can't...

    I have had it set there before, but I can't remember if I had a flight plan in the 480 at that time. I usually leave the map source set to GPS2 (my AFS GPS) for redundancy and position...
  2. Replies
    3
    Views
    6,641

    GNS 480 flight plan

    Will the AFS4500 display the flight plan for a GNS480? The 4500 seems to drive the AP fine based on the 480 flight plan, but it does not display the flight plan on the 4500 map. Am I missing...
  3. Replies
    4
    Views
    8,294

    Checked it out tonight and my GTX 330 output...

    Checked it out tonight and my GTX 330 output serial stream was configured wrong. Reconfigured so it should work now.
  4. Thread: Afs gps

    by Bill Rogers
    Replies
    14
    Views
    19,649

    That is exactly right.

    That is exactly right.
  5. Replies
    4
    Views
    8,294

    Can traffic be turned on and off?

    I am still in the process of learning the 4500 menus. Currently traffic is being displayed on my GNS480, but is not showing up on the AFS4500. The GTX330 is receiving the ICARUS input from the...
  6. Thread: Afs gps

    by Bill Rogers
    Replies
    14
    Views
    19,649

    Just bought one about a month ago and it had...

    Just bought one about a month ago and it had magnets. It was not hard to remove them with the soldering iron method.
  7. Trevor, I tried calling this afternoon...

    Trevor,

    I tried calling this afternoon when I was at the airport, but I could not catch you (message said you were on the phone). I checked the function of following interfaces to the 480...
  8. I have finally installed the AFS4500. It gets a...

    I have finally installed the AFS4500. It gets a GPS position from the GNS480 (GNAV 1) and the VDI works on the startup check from the 480 (haven't noticed the CDI yet). I also haven't verified that...
  9. Thanks Trevor. Does the 480 send LAT/LONG across...

    Thanks Trevor. Does the 480 send LAT/LONG across the ARINC to use as the primary source, or will the 4500 be using the AFS GPS for the primary LAT/LONG with this config? Any internal cross checking...
  10. AFS 4500 Serial Port Configuration Questions

    I am preparing to wire the serial ports for my AFS4500. I would like to use a seperate GPS for the Lat/Long input so I can cross check the GNS-480 position. The following is the configuration I was...
  11. Replies
    4
    Views
    10,144

    Did this ever get resolved? I am planning a...

    Did this ever get resolved? I am planning a panel upgrade and I have a GNS480. What was needed to make it work? Any info is apriciated. Thanks.

    Bill
Results 1 to 11 of 11