Search:

Type: Posts; User: sahrens

Page 1 of 2 1 2

Search: Search took 0.01 seconds; generated 5 minute(s) ago.

  1. Replies
    1
    Views
    801

    UPDATE: The seems to be an issue with iPad...

    UPDATE: The seems to be an issue with iPad connectivity with the Dynon WIFI system. When my iPhone connects it is given the IP address in the 192.x.x.x address space. But when my iPad after a few...
  2. Replies
    1
    Views
    801

    iPad connectivity issue

    I recently upgraded to a iPad mini 6 running iOs 16.6.1, it has WIFI and Cellular and I am running Foreflight (current version.) This new iPad is replacing my old mini version 4 which does not...
  3. Replies
    2
    Views
    6,854

    Update

    Any update to getting this label changed to a user specified term?
  4. Replies
    0
    Views
    8,877

    V16-06-15 and Landing override

    During take-off acceleration the tonal stall warning starts at about 30 KIAS and continues until about 70 KIAS during climb out. I have adjusted Landing Override for the landing sequence and I do...
  5. Replies
    0
    Views
    3,864

    V16-06-15 and Alert Tone Start Bar

    In regard to this information

    "Setting the Alert Tone Start Bar to 16 will cause the AOA tones to start beeping at the normal approach AOA and become a steady tone at the red bar (15% above...
  6. Thread: audio aoa

    by sahrens
    Replies
    19
    Views
    108,072

    Shawn, I can be a beta tester if you need an...

    Shawn, I can be a beta tester if you need an additional user. I'm located in Portland OR area. I have an RV-7 with 5000T EFIS
  7. Replies
    2
    Views
    6,854

    EarthX Temperature

    I have used the carburetor temp probe to monitor the temperature of my EarthX battery. The EFIS displays carb XX for the temperature. Any chance that label could be changed to a user entered four...
  8. Thread: audio aoa

    by sahrens
    Replies
    19
    Views
    108,072

    Any update on the release? I would really like...

    Any update on the release? I would really like to have access to the AOA tones.

    Thank you.

    Scott
  9. Replies
    1
    Views
    52,305

    Modifying AOA data

    Flying an RV-7 and I would like to adjust the AOA settings to increase or decrease when the warnings activate. Is there a value that corresponds to approximately 1 KIAS change? For example my...
  10. Replies
    3
    Views
    91,912

    I spoke with tech support yesterday afternoon and...

    I spoke with tech support yesterday afternoon and learned this will be resolved in an upcoming release.
  11. Replies
    3
    Views
    91,912

    The donut is clearly visible, especially the...

    The donut is clearly visible, especially the green portion. The audio works and is clearly understandable and the flap position indicator is operating normally and clearly visible. The data comes...
  12. Replies
    3
    Views
    91,912

    AOA brightness adjustment

    Is there a method to adjust the brightness of the AOA chevrons? I
  13. Replies
    2
    Views
    45,445

    Thank you!

    Thank you!
  14. Replies
    2
    Views
    45,445

    Backvolts, volts1 & volts2

    I have a 5500T with a TCW 6ah backup battery. When I download the logs the system records three voltages, backvolts, volts 1 and volts 2.

    1. Where is backvolts measuring voltage? Given my...
  15. Replies
    1
    Views
    4,356

    Checklist limits

    Is there a limit to the number of lines within a checklist? I can not get items beyond line 11 on the CHKLST1.LINEn area of the checklist to display (AFS 5500T.) I have recreated the checklist to...
  16. Replies
    1
    Views
    90,756

    5500 and Dynon firmware release

    Dynon released a firmware update for the GPS 2020 to fix the NACv bug on the ADSB report among other issues. When will AFS release that update for the Dynon equipment through the AFS 5500?

    Thanks
  17. Replies
    0
    Views
    67,115

    AF-5500 and TCW drain

    I have a AF-5500 with the TCW backup battery. Recently the TCW battery failed. TCW stated the battery had been discharged to the point of damaging a cell. I had to replace the battery. Other than...
  18. Replies
    2
    Views
    6,343

    Bringing this thread back up. Yesterday I was...

    Bringing this thread back up. Yesterday I was attempting to load flight plans from my iPad mini 4 via Foreflight to my AFS 5500T. I received the same error code on each of several attempts,...
  19. Thread: TFRs

    by sahrens
    Replies
    5
    Views
    12,166

    I flew day and verified that I was receiving...

    I flew day and verified that I was receiving ground station data and could view the TFR text data on the TFR page. What I misunderstood was how the TFR and WX graphic data was displayed. That data...
  20. Thread: TFRs

    by sahrens
    Replies
    5
    Views
    12,166

    Well, I thought I had wx turned on. Now I will...

    Well, I thought I had wx turned on. Now I will have to check it out tomorrow morning. I am getting traffic through ads-b
  21. Thread: TFRs

    by sahrens
    Replies
    5
    Views
    12,166

    TFRs

    I have a 5500T and the Dynon 470. The 5500 is not displaying any TFRs or wx. I am receiving traffic.

    Is this a know software issue?

    Thank you.

    Scott
  22. Replies
    5
    Views
    6,220

    Is it possible to rename the carb temp label that...

    Is it possible to rename the carb temp label that is displayed on the engine screen? I am using it to monitor the battery temp of my EarthX battery, so Batt Temp would be ideal.

    Thank you.
    ...
  23. Replies
    5
    Views
    6,220

    Temperature measurement

    I would like to hook a J or K type thermocouple to the Dynon EMS to monitor my EarthX battery temperature. The battery is located on the firewall in the standard location for a Vans RV-7.

    1. May...
  24. Replies
    1
    Views
    5,615

    5500T data logs

    I have my main buss connected to the SV-EMS pin 1 to measure alternator/battery voltage into the aircraft. I connected the IBBS battery information to pin 13 on the EFIS expansion plug. When I pull...
  25. Replies
    4
    Views
    11,074

    Thank you for that clarification. Scott

    Thank you for that clarification.

    Scott
Results 1 to 25 of 28
Page 1 of 2 1 2