I have had it set there before, but I can't remember if I had a flight plan in the 480 at that time. I usually leave the map source set to GPS2 (my AFS GPS) for redundancy and position...
Type: Posts; User: Bill Rogers
I have had it set there before, but I can't remember if I had a flight plan in the 480 at that time. I usually leave the map source set to GPS2 (my AFS GPS) for redundancy and position...
Will the AFS4500 display the flight plan for a GNS480? The 4500 seems to drive the AP fine based on the 480 flight plan, but it does not display the flight plan on the 4500 map. Am I missing...
Checked it out tonight and my GTX 330 output serial stream was configured wrong. Reconfigured so it should work now.
That is exactly right.
I am still in the process of learning the 4500 menus. Currently traffic is being displayed on my GNS480, but is not showing up on the AFS4500. The GTX330 is receiving the ICARUS input from the...
Just bought one about a month ago and it had magnets. It was not hard to remove them with the soldering iron method.
Trevor,
I tried calling this afternoon when I was at the airport, but I could not catch you (message said you were on the phone). I checked the function of following interfaces to the 480...
I have finally installed the AFS4500. It gets a GPS position from the GNS480 (GNAV 1) and the VDI works on the startup check from the 480 (haven't noticed the CDI yet). I also haven't verified that...
Thanks Trevor. Does the 480 send LAT/LONG across the ARINC to use as the primary source, or will the 4500 be using the AFS GPS for the primary LAT/LONG with this config? Any internal cross checking...
I am preparing to wire the serial ports for my AFS4500. I would like to use a seperate GPS for the Lat/Long input so I can cross check the GNS-480 position. The following is the configuration I was...
Did this ever get resolved? I am planning a panel upgrade and I have a GNS480. What was needed to make it work? Any info is apriciated. Thanks.
Bill