Yes, the calibration and test seem to perform fine, but engaging the autopilot, either on the ground or in the air results in the engage light blinking on then immediately off. Might there be any...
Type: Posts; User: rfogg
Yes, the calibration and test seem to perform fine, but engaging the autopilot, either on the ground or in the air results in the engage light blinking on then immediately off. Might there be any...
The servos have been calibrated and the test runs fine. I have the FD enabled and have selected SV Autopilot as the autopilot type. When I go to the AP page and select Level or Engage, the engage...
I am troubleshooting the connection of two Dynon SV32 servos to my 5600. They were previously successfully driven by a Dynon D10A. The Calibration/Advanced SV Network page shows that they are...