Search:

Type: Posts; User: Bicyclops

Search: Search took 0.01 seconds; generated 1 minute(s) ago.

  1. Replies
    14
    Views
    6,722

    Please. Ed Holyoke

    Please.

    Ed Holyoke
  2. Replies
    2
    Views
    3,243

    I mistyped. It is 158w that i see. Don't know...

    I mistyped. It is 158w that i see. Don't know where 9156 came from. They couldn't have messed with the antenna connection as that is behind the baggage bulkhead. I'll be pulling that this month for...
  3. Replies
    2
    Views
    3,243

    Transponder low power

    Howdy,

    I had by transponder check done recently and ever since I get an intermittent alert of Transponder TX LOW PWR 9156W).

    I was not present when the xpdr check was done. Is there a special...
  4. Replies
    6
    Views
    5,275

    The EM screen is the one with the engine monitor...

    The EM screen is the one with the engine monitor board built in, right? That is my PFD and it is where I was trying to calibrate it. I'll try it again.

    Ed
  5. Replies
    6
    Views
    5,275

    Not sure I understand that. It is wired directly...

    Not sure I understand that. It is wired directly to the EFIS. I do not have an EMS as they hadn't been incorporated at that time. I'll try and dig up my as built wiring diagram to see what pins. It...
  6. Replies
    6
    Views
    5,275

    Ping. The flap position was working before the...

    Ping. The flap position was working before the upgrade, but not after.

    Ed
  7. Thread: V16 Software

    by Bicyclops
    Replies
    13
    Views
    11,397

    That works. There is no "V16" button, but when it...

    That works. There is no "V16" button, but when it is putting charts on the thumb drive it shows Dynon Skyview charts on the activity line.

    Ed
  8. Thread: V16 Software

    by Bicyclops
    Replies
    13
    Views
    11,397

    software link?

    Howdy,

    I've downloaded the purportedly latest version of the data manager software from their site. No V16 button. I've emailed them and tried to call with no success. Do you have a link to the...
  9. Replies
    6
    Views
    5,275

    Where's my flaps?

    Howdy,

    I loaded the V16 software on my 5600s, hardware V7 and now my flap position sensor is no longer working. I'm getting flap overspeed warnings. Operating the flaps does not bring up the...
  10. Replies
    11
    Views
    130,952

    Available? Gonna be needing weather depiction to...

    Available? Gonna be needing weather depiction to fly to Osh.

    Ed Holyoke
  11. Replies
    1
    Views
    90,751

    Yeah, what he said and...updated to firmware on...

    Yeah, what he said and...updated to firmware on the GPS250. I've got one of each and the 250 doesn't know what time it is.

    Ed Holyoke
  12. Replies
    10
    Views
    346,422

    OK, I set the xpdr to ADS-B in = UAT only. I also...

    OK, I set the xpdr to ADS-B in = UAT only. I also enabled TIS. I got "OK" on the display. I showed ADS-B and TIS-B targets. That is all good. I did a PAPR and failed NIC. That might have been because...
  13. Replies
    10
    Views
    346,422

    Howdy Bob, Looking for own ship N number in...

    Howdy Bob,

    Looking for own ship N number in the data stream makes some sense. Then, I assume, the EFIS is supposed to scrub own ship out of what it displays, though it doesn't always seem to. I...
  14. Replies
    10
    Views
    346,422

    No Radar, missing targets

    Howdy,

    My 5600 EFIS is showing "No Radar" in the lower right corner. I display traffic and I have METAR/TAF/TFRs. I didn't see a target displayed for that Gulfstream that I shared Newhall Pass...
  15. Replies
    2
    Views
    6,895

    I brought up the ADS-B info page and saw a list...

    I brought up the ADS-B info page and saw a list of 3 TFRs, 2 of which were listed as expired. They are 7/3555-1, which is the New Years Day Rose Bowl game TFR, and 7/3701-1, which is the fire TFR in...
  16. Replies
    2
    Views
    6,895

    Negative TFRs

    Howdy,

    Running 2 5600s with GPS2020 and mode S for ADS-B out and the single channel ADS-B in box. I've got the 11/1/17 version of the software. I am not seeing TFRs on the displays even though...
  17. Thread: Floscan 201

    by Bicyclops
    Replies
    2
    Views
    22,434

    Floscan 201

    Howdy,
    I'm using a Floscan 201 and after 2 engine runs I see 0 fuel flow indication. I see that pin #15 is +5v. Floscan's website says that it wants 12-15v. Is there a suitable pin on the connector...
  18. Thread: Android apps

    by Bicyclops
    Replies
    3
    Views
    5,767

    Flight plan format

    Howdy Shawn,

    What format/file name does an imported flight plan have to have?

    Thanks,

    Ed
  19. Thread: Android apps

    by Bicyclops
    Replies
    3
    Views
    5,767

    Android apps

    Howdy,

    For those of us who use Android instead of IOS, is there any plan to support communication of flight plans, ADS-B output, etc. to and from apps like Avare via WiFi?

    Thanks,

    Ed
  20. Thread: Gps 2020

    by Bicyclops
    Replies
    2
    Views
    8,576

    Gps 2020

    Howdy,

    Now that the Dynon GPS-2020 is shipping, does the current software support it for fully compliant ADS-B out?

    Thanks,

    Ed Holyoke
Results 1 to 20 of 20