Search:

Type: Posts; User: krheacm

Search: Search took 0.00 seconds.

  1. http://advanced-flight-systems.com/forum/threads/2051-Existing-Transponder-codes-reap

    To further test the rs232 signals, i built a d9M to d9fm with a 3 volt led on the TX line and a 3 volt led on the RX line. You could clearly see a heartbeat and when key strokes were entered on the...
  2. 1.Remove AFS custom made harness. (57505...

    1.Remove AFS custom made harness. (57505 diagram), dis-assemble and remove rs232 wires from d15 connector to d9 connector and inspect d-sub pins, check twist (not consistent) Meg-ohm wire 20M scale...
  3. Jonathon: Ok thanks will try and get the stx165R...

    Jonathon: Ok thanks will try and get the stx165R checked out.

    Keith
  4. Existing Transponder codes reappearing regardless of new code.

    AF5600 with ACm and sandia STX165R transponder. AS I entered controlled airspace at altitude and 140 KTs, ATC gave me a 4400 squawk code and i was acknowledged and the reply indicator was flashing. ...
  5. Replies
    3
    Views
    2,624

    full screen/split screen modes

    AF5600, ifd410, I have my single af5600 display in split screen mode, and i can't figure out how to get it out of split screen. The split screen percentage buttons are not selected, I think read...
  6. Shawn: I created a diagram in eazydraw that show...

    Shawn: I created a diagram in eazydraw that show the connections to the lr3c. Here is a link. https://www.dropbox.com/s/g97neka991kdsbq/57840%20harnes%20B%26%20C%20regulatorA.jpg?dl=0

    Thanks

    ...
  7. B & C alternator, external LR3C Voltage regulator

    I only have an order in place and haven't recieved any Advanced Equipment yet. My O-320 has a B& C alternator that uses an External Voltage Regulator and i am curious if i'll e able to connect it...
Results 1 to 7 of 7