Search:

Type: Posts; User: Isaac Becktold

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    26,664

    You are correct. Most microphone bias voltages...

    You are correct. Most microphone bias voltages are +/- 5V. Telex's Airman series headsets are noise cancelling and use this voltage to accomplish it.

    As far as your headset with our intercom-...
  2. You have to purchase one Map Software unlock key....

    You have to purchase one Map Software unlock key. This will cover every screen in the aircraft. The same goes for the other options we offer. Just one for the entire aircraft. If you have any other...
  3. Replies
    4
    Views
    9,780

    Start with a general visual inspection of the...

    Start with a general visual inspection of the area. Since the problem is more or less coming and going, I would check to see if anything is loose, becoming loose, ect. Do a pull test on the...
  4. Replies
    5
    Views
    9,197

    You will have to ensure the configuration on your...

    You will have to ensure the configuration on your GTX-327 matches the wiring on the harness. If the AFS-5600 is wired into pin #2, confirm the configuration for that serial port is ICARUS ALT. You...
  5. Replies
    7
    Views
    9,710

    Yes, it is different than the battery on top....

    Yes, it is different than the battery on top. This battery is in the rear of the unit. Behind the 6 screws which I mentioned above. The battery information is - 7.4V 2200mAh Li-Ion. P/N: EPG-1337....
  6. Replies
    7
    Views
    9,710

    Yes, its pretty easy. On the backside of the...

    Yes, its pretty easy. On the backside of the instrument there are 6 screws holding the battery cover plate in position. The battery is located behind this plate.
  7. Replies
    7
    Views
    10,319

    Troberts- Check your O.A.T wiring. Either a...

    Troberts- Check your O.A.T wiring. Either a broken wire, shorted wire, or incorrect pin designation. Was it working at some point then just stopped working all of a sudden? A little more background...
  8. Replies
    7
    Views
    10,319

    Your best bet would be to make a SHIFT ADJUST. Go...

    Your best bet would be to make a SHIFT ADJUST. Go to--- Set < Hold Cal < Select OAT. Enter in a Shift Adjust until the OAT readout is where you would like it to be. Also, ensure your wiring is...
Results 1 to 8 of 8