Search:

Type: Posts; User: rvdave

Page 1 of 9 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    11
    Views
    219

    The reason I turned traffic off was because my...

    The reason I turned traffic off was because my ownship was always showing up on ifd550 triggering an annoying traffic alert. From what I understand there’s no way to filter ownship from ifd550 so I...
  2. Replies
    11
    Views
    219

    Hope this helps 501 502 503 504

    Hope this helps

    501

    502

    503

    504
  3. Replies
    11
    Views
    219

    Not sure if you went through this but here is...

    Not sure if you went through this but here is setup from afs manual.
  4. Replies
    11
    Views
    219

    Next time at the hangar I’ll get some photos

    Next time at the hangar I’ll get some photos
  5. Replies
    11
    Views
    219

    You should not get the 429 data not received or...

    You should not get the 429 data not received or datalink error message if everything is wired and configured correctly, but you also won’t get traffic to ifd540. You should get weather though to...
  6. Replies
    1
    Views
    103

    5600 stuck on white afs screen

    Just all of a sudden my pfd 5600 will not boot up, is stuck on first white afs screen. Tried manual reboot, removing power to reboot, starting in backup battery mode. Can I load software while it...
  7. Thread: Vpx disappears

    by rvdave
    Replies
    5
    Views
    999

    Mine still does it sporadically but haven’t been...

    Mine still does it sporadically but haven’t been able to spot a pattern to it nor have I yet sent logs in. On my list though to follow up on.
  8. Thread: Vpx disappears

    by rvdave
    Replies
    5
    Views
    999

    No xm but I will send logs to see if you can find...

    No xm but I will send logs to see if you can find something, thanks.
  9. Thread: Vpx disappears

    by rvdave
    Replies
    5
    Views
    999

    Vpx disappears

    Been a continuous nuisance on secondary not primary screen that my electrical configuration of vpx goes gray on both secondary screens. Have to every now and then add and save vpx in order to...
  10. Thread: NAV Radio

    by rvdave
    Replies
    3
    Views
    908

    The VAL2KR remote nav receiver works well with...

    The VAL2KR remote nav receiver works well with afs 5600. Initially I had trouble but it ended up being a bad coax connection in my wiring. Now I can confidently use it as vor guidance or ils...
  11. Thread: AOA calibration

    by rvdave
    Replies
    10
    Views
    2,738

    Not understanding how those numbers correspond to...

    Not understanding how those numbers correspond to display colors, should that number in aoa display match the bar color segment in mode actually flying?
  12. Thread: AOA calibration

    by rvdave
    Replies
    10
    Views
    2,738

    Recalibrated aoa and got satisfactory results. ...

    Recalibrated aoa and got satisfactory results. Now question is what parameter controls when the aoa comes on screen during declutter and what triggers when audio warning sounds angle angle push and...
  13. Replies
    0
    Views
    804

    Afs 5600 traffic to ifd550

    I have adsb472 to 5600 and recently wired in my ifd550 per afs manual to get traffic info and weather to the ifd. So far everything is communicating but I’m getting a ghost traffic indicating my own...
  14. Thread: Inset windows

    by rvdave
    Replies
    0
    Views
    692

    Inset windows

    Wondering the possibility of getting the hsi inset as a window option. It would make a good backup navigating monitor on another screen rather than having to fill the screen with the efis and lose...
  15. Thread: AOA calibration

    by rvdave
    Replies
    10
    Views
    2,738

    My flap angle sensor is tied to vpx, 5600.

    My flap angle sensor is tied to vpx, 5600.
  16. Thread: AOA calibration

    by rvdave
    Replies
    10
    Views
    2,738

    The donut comes on with full flaps only, not sure...

    The donut comes on with full flaps only, not sure how it would be half calibrated but I’ll try it again and report back with changes, but after this Michigan winter weather settles down.
  17. Thread: AOA calibration

    by rvdave
    Replies
    10
    Views
    2,738

    Photo of aoa settings ...

    Photo of aoa settings


    https://i.postimg.cc/RJzsHkLQ/533-B6-C6-B-3-B48-497-E-8-F4-E-E4-E46-D38-CC78.jpg
  18. Thread: AOA calibration

    by rvdave
    Replies
    10
    Views
    2,738

    AOA calibration

    I’ve never been able to get my aoa calibrated to where it is close to being accurate or trusted. Not sure if the button press during calibration is super critical or if the timing of the flying...
  19. Replies
    3
    Views
    1,666

    After your suggestion that it may be input...

    After your suggestion that it may be input related I increased volume out of 5600 to audio panel and that took care of that problem. Must have been below input threshold of audio panel.
  20. Replies
    3
    Views
    1,666

    I have the remote PS Engineering pac15ex with the...

    I have the remote PS Engineering pac15ex with the audio input to either 1,2, or 4– not sure at this time but it’s an unswitched input to the audio panel. I know I didn’t tie it to 3 since that one...
  21. Replies
    3
    Views
    1,666

    Audio annunciations cut out midsentence

    This has been going on for a while with my 5600 and current software and have been trying to see diagnosable patterns but haven’t been able to. The aural annunciations cut out mid sentence...
  22. Replies
    1
    Views
    1,716

    Earthx battery monitoring thru efis

    Recently installed the earthx battery with fault line wired to input to efis. During a recent fault the warning came on the screen but it doesn’t flash according to a logical code to interpret what...
  23. Recently did the ifr checkride in my rv10 3...

    Recently did the ifr checkride in my rv10 3 screen afs system. Examiner was ok with allowing only map page on pfd and efis on mfd center screen. That allowed non-precision approach to be performed...
  24. Replies
    3
    Views
    1,975

    By chance found a defective bnc connection at nav...

    By chance found a defective bnc connection at nav radio input. Was a strand of ground cable caught between crimp ring and center conductor intermittently shorting. Must have been a late night...
  25. Replies
    3
    Views
    1,975

    Only checking connectors, maybe where the problem...

    Only checking connectors, maybe where the problem lies.
Results 1 to 25 of 217
Page 1 of 9 1 2 3 4