-
Oil Pressure Transducer
I have a AF-3000 Non-S-type EFIS and EMS. I have recently changed my oil pressure transducer because it was acting up. I had a 0-100 psi. Swift type unit, and replaced it with a 0-150 psi. Swift unit. I didn't realize I had purchased a 0-150 psi unit until I installed it. I'm assuming the unit will output the correct pressure regardless of it's operating range. Is that a correct assumption?
Thanks in advance.
Steve Miceli
Van's RV-6A
IOF-360 FADEC
-
Different sensors react differently to pressure changes. You may need to re-calibrate the sensors lookup table within the EFIS. Email support@advanced-flight-systems.com with the part number that you purchased and they can forward you the instructions.