The software got updated on my AFS and now the autotrim feature is not working. Is there a box that needs checked somewhere?
Thanks
Printable View
The software got updated on my AFS and now the autotrim feature is not working. Is there a box that needs checked somewhere?
Thanks
Do you have the SV-AP-PANEL connected?
Have you scanned for it in the Advanced SV-Network?
Have you calibrated the trim in Elevator Trim calibration page?
It is connected.
It used to work fine before the shop updated the software.
Have not scanned or calibrated.
Do these steps have to be done everytime the software is updated?
Thanks