Howdy,
I'm using a Floscan 201 and after 2 engine runs I see 0 fuel flow indication. I see that pin #15 is +5v. Floscan's website says that it wants 12-15v. Is there a suitable pin on the connector for that?
Thanks,
Ed Holyoke
Printable View
Howdy,
I'm using a Floscan 201 and after 2 engine runs I see 0 fuel flow indication. I see that pin #15 is +5v. Floscan's website says that it wants 12-15v. Is there a suitable pin on the connector for that?
Thanks,
Ed Holyoke
you should see flow even right after startup - I see flow even when I use the fuel pump...
Are you sure the indicator in the FF needs 12v ?? Think it comes with 3 wires: +, ground, and signal, but I could be wrong...
When we used Flowscan a long time ago they were 5v compatible. You could try feeding it with Pin 2 Trim Power at +10v to see if it works better.